MUNTER HITCH

The Munter hitch is a type of safety hitch and is technically not a real knot, but rather a brake loop. It is used for protecting the lead and follower and when lowering down the climbing partner, and works best in a pear-shaped HMS carabiner.

CLOVE HITCH

The clove hitch is a safety knot and is ideal for a personal anchor. It is attached at the anchor’s center point using a locking carabiner. The length of the clove hitch can be set precisely and adjusted quickly: You pull on the center ridge of the knot and push the rope in the desired direction. Inconvenient untying or removal of your personal anchor becomes unnecessary.

FIGURE EIGHT KNOT

The figure eight loop has been established as a standard knot for roping up and tying in. It is used for sport and alpine climbing.

NOTE: The finished knot has to be tightened and all its strands double checked for completion.

OVER HAND KNOT

The over hand knot is used as a joining knot: It is used for joining two rope ends and is recommended above all for light loads (rappelling, prusiking) or for knots that need to be applied from a climbing position (at a tunnel, or a knot loop). Although overall it offers a less secure knot, with long ends it is totally sufficient for these levels of strain.

GIRTH HITCH

On the one hand, the girth hitch is a quick and simple knot for connecting slings. On the other hand, girth hitches can also be used to fasten slings to trees and to attach a personal anchor sling to a harness and carabiner.

Beware: Joining knots such as the girth hitch are vulnerable when they are under strain and scrape on the rock face, for example when setting top-rope anchors over rock edges. Sling material can get damaged quickly!

PRUSIK KNOT

The prusik knot is a friction hitch knot that can act as an aid during ascent: It can be shifted when not under strain, but sticks in place when under strain. On alpine rock faces, the prusik knot is most often used for a safety back up while rappelling. A cord is wrapped two or three times – depending upon the rope thickness – around both strands. When rappelling the climber shifts the knot. The prusik hereby serves to protect the rappelling climber. A 5–6mm thick cord – ideally made of Kevlar or Dyneema – is normally used for prusik knots.

KLEMHEIST KNOT

The Klemheist knot is an alternative to the prusik, but only holds optimally in one direction while being pushed in the other. This knot is particularly suitable for sling material, as even narrow slings hold optimally with this knot.

BOWLINE ON A BIGHT

The climber needs a central point on the anchor where the carabiners for the personal anchor and partner's belay can be clipped on. The bowline on a bight can be used as the central point. A bowline on a bight knot uses a double bight and puts little strain on the belt material. It is also very strong and does not tighten when under strain. A bowline on a bight is normally set up before the climb with a 120cm sling. While climbing, the sling, with two locking carabiners, is always on hand.